- Joined
- Sep 20, 2008
- Messages
- 17,644
- Points
- 113
All 5 LaserBee A LPMs SOLD !!!
Thanks.
We are only offering five (5) units on this Sales Thread..
As you may already know we had been working on another Economical
Laser Power Meter that is offered on eBay for $179.99 plus shipping.
It was given the name LaserBee A for Analog....
It is a very small 3-1/2 Digital Display Non-Data Logging LPM.
( 2.5" X 4" X 1.5" )
It has additional circuitry that enables True Zeroing by way of the
Zeroing control on the exterior of enclosure.
We had left a 1.5W laser on the Sensor for 20 minutes to let the
Thermopile radiator heat up a bit then removed the Laser beam
and let the display drop to below Zero and stabilize there.
The Zero control was easily able to Zero the reading to take another
Laser power reading immediately.
There is room inside the enclosure to install our DL2-Module to turn
it into a Data Logging LPM which can read higher powers than the on
board 3-1/2 Digital Display.
Our DL2-Module will be discounted when purchasing it at the same
time as the LaserBee A. Contact us prior to placing your order.
It is to be noted that the DL2-Module is to be installed by the buyer.
You can read up on the DL2-Module here....
----> http://laserpointerforums.com/f64/n...d-data-logging-your-lpm-62132.html#post882400 <----
The LaserBee A uses the same large and stable 2.5W rated Thermopile
as used on the LaserBee 2.5W USB.
The LaserBee A runs off a single standard 9volt battery and draws a
mere 32mA...
It also uses an LDO regulator on the PCB to ensure stable readings
even if battery voltages sag or change with use.
Note that the installed 3-1/2digital display will only display up to 2
Watts.
We only have 5 of these 2nd Generation Laserbee A LPMs to offer on
LPF at this time at this discounted price.
==================================================
To purchase this new calibrated Prototype LaserBee A + Thermopile...
just send a PayPal payment of $149.99Cnd plus $18.15Cnd S/H to
our PayPal ID:
sales@laserbeelpm.com
If payment is not made in Canadian Funds it will be refunded...
(PayPal rapes us when we transfer US fund to our Canadian bank..)
Make sure your Full Name and Complete address is included with your
payment.
DON'T FORGET TO INCLUDE YOUR LPF Username...
Please state what you are paying for in the Note...
YOU MUST SEND ANY PAYMENTS AS GOODS so that we can print
out a PayPal Shipping Label..
For shipping other than Canada or the USA you will need to PM me for
additional Shipping costs.
Jerry
You can contact us at any time on our Website: J.BAUER Electronics
Thanks.
We are only offering five (5) units on this Sales Thread..
As you may already know we had been working on another Economical
Laser Power Meter that is offered on eBay for $179.99 plus shipping.
It was given the name LaserBee A for Analog....
It is a very small 3-1/2 Digital Display Non-Data Logging LPM.
( 2.5" X 4" X 1.5" )
It has additional circuitry that enables True Zeroing by way of the
Zeroing control on the exterior of enclosure.
We had left a 1.5W laser on the Sensor for 20 minutes to let the
Thermopile radiator heat up a bit then removed the Laser beam
and let the display drop to below Zero and stabilize there.
The Zero control was easily able to Zero the reading to take another
Laser power reading immediately.
There is room inside the enclosure to install our DL2-Module to turn
it into a Data Logging LPM which can read higher powers than the on
board 3-1/2 Digital Display.
Our DL2-Module will be discounted when purchasing it at the same
time as the LaserBee A. Contact us prior to placing your order.
It is to be noted that the DL2-Module is to be installed by the buyer.
You can read up on the DL2-Module here....
----> http://laserpointerforums.com/f64/n...d-data-logging-your-lpm-62132.html#post882400 <----
The LaserBee A uses the same large and stable 2.5W rated Thermopile
as used on the LaserBee 2.5W USB.
The LaserBee A runs off a single standard 9volt battery and draws a
mere 32mA...
It also uses an LDO regulator on the PCB to ensure stable readings
even if battery voltages sag or change with use.
Note that the installed 3-1/2digital display will only display up to 2
Watts.
We only have 5 of these 2nd Generation Laserbee A LPMs to offer on
LPF at this time at this discounted price.
==================================================
To purchase this new calibrated Prototype LaserBee A + Thermopile...
just send a PayPal payment of $149.99Cnd plus $18.15Cnd S/H to
our PayPal ID:
sales@laserbeelpm.com
If payment is not made in Canadian Funds it will be refunded...
(PayPal rapes us when we transfer US fund to our Canadian bank..)
Make sure your Full Name and Complete address is included with your
payment.
DON'T FORGET TO INCLUDE YOUR LPF Username...
Please state what you are paying for in the Note...
YOU MUST SEND ANY PAYMENTS AS GOODS so that we can print
out a PayPal Shipping Label..
For shipping other than Canada or the USA you will need to PM me for
additional Shipping costs.
Jerry
You can contact us at any time on our Website: J.BAUER Electronics
Attachments
Last edited: