Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers



Aixiz heat sinked diode holders

andy_con

New member
Joined
May 24, 2007
Messages
3,394
Points
0
If anyone needs a diode holder im doing the below for £15 each + postage

you can see the sizes and how small is it, fully insulated and heat sinked.

mounting hole in the pic is m3 but can be tapped for m4 if requested.

the aixiz holders pop out so the diode can be pressed into the aixiz holders as normal, then inserted back into the mount. its a very tight fit but onces the aixiz housings have been inserted and turned to gain maximum power just add a dab of glue to the back of the aixiz holder to stop them moving.

very simple yet effective holder.

at the last UK meet i had a dual open can red set in an identical holder running at 250mw each all day and it wasnt even warm at the end of the day.

the pics are of a test setup, the proper ones will have a better finish and the holes will be the same level




 



Benm

Well-known member
Joined
Aug 16, 2007
Messages
8,113
Points
113
That looks really good - can't wait to play around with it :)

I hope my idea of putting a green module in one of the aixiz slots will work, but even if it doesnt, i'm sure it will make a very nice dual-LOC.
 

andy_con

New member
Joined
May 24, 2007
Messages
3,394
Points
0
providing the green is 12mm the same as an aixis it shouldnt be a problem
 

Benm

Well-known member
Joined
Aug 16, 2007
Messages
8,113
Points
113
An update for this thread as well: See the heatsink/holder in action here: http://laserpointerforums.com/f47/rgy-optics-under-construction-50868-new-post.html

Electrical isolation is really nice to have, and it fits both aixiz modules and o-like greens with a little effort. Recommended unit, i think the two tapped holes should be standard though, makes for much better thermal contact and prevents the thing spinning around when mounting it.
 

FlightLevel350

New member
Joined
Apr 2, 2009
Messages
355
Points
0
Are you still making these? I would like one for a dual LOC build I am making for my scanner. PM me with the payment details if you are.

FL350
 

532 with Envy

Well-known member
Joined
Jun 19, 2010
Messages
1,489
Points
63
Very nice....PM sent on two set-up!
Thanks for putting these together, I'm getting there slowly with my table.

Thanks
Carl
 




Top