- Joined
- Feb 19, 2010
- Messages
- 443
- Points
- 0
hi,
i need a way to adjust the power of a green laser module for my upcoming build of an RGB. is it possible to simply add a potentiometer between the modules driver and the power source to adjust power? or will i need to make a ddl driver for it (if so how much should say- a 50mw green be run at)?
thanks for your help, Hugo.
Edit:
perhaps if i desolder one end of the resistor on the driver board and solder a potentiometer to this end, and solder the other end of the potentiometer back onto the driver board in place of where the resistors second lead would have gone, i could adjust current?
i need a way to adjust the power of a green laser module for my upcoming build of an RGB. is it possible to simply add a potentiometer between the modules driver and the power source to adjust power? or will i need to make a ddl driver for it (if so how much should say- a 50mw green be run at)?
thanks for your help, Hugo.
Edit:
perhaps if i desolder one end of the resistor on the driver board and solder a potentiometer to this end, and solder the other end of the potentiometer back onto the driver board in place of where the resistors second lead would have gone, i could adjust current?
Last edited: