adjust the LED driver for M140

[DaTT]

Hello, Please advice. How do I adjust the LED driver for M140? I have dummy loads with 6 diodes 1N4007 and 1ohm resistor. What I measured the voltage on the resistor? I tried to set 1V on the resistance and the diodes I appear 5,07 V is too much? When I set 0.950 V to 4.98 V diodes can be measured. I am afraid to connect M140 before it set up correctly. What are the correct settings? Thank You.

 

[NKO29]

Well, you aren't actually looking to regulate voltage... You want to measure the CURRENT output of the driver. Laser diodes aren't voltage sensitive UNLESS it's too low.

 

[DaTT]

I used the measurements as shown. Then reading in mV will be the same as the current in mA. What values would therefore be set?