- Jan 29, 2012
Just opening a new thread for my completed lasers!
Below is my latest build I plan to add more as they are built, but I must find some drivers first...
The laser FS is on the right and the 465 on the left has already been sold!
Specs 7 W 450 M44
Sinner MS V1 host (new design) with copper core!
Copper Module with extended copper back half
Lazeerer SXD with pot set at 4.5 A and heat sinked directly to host
24AWG super flexible silicone wire
Takes 2 x 16340 batteries (not supplied)
Please note Paypal fees applicable if payment not sent as F&F.
These are the completed V1s
Notes: I dont actually know what the duty cycle of these lasers are, however as I prefer to look after my diodes, I generally stick to shorter run times to extend their lifetimes. As a guideline, I would recommend 1 min on and 1.5 mins off - at 1 min the head of the laser will be getting warm.
I can also offer GITD* on any build for an extra $ 10 and polishing is also offered for an additional $ 20.
*New generation of Europium doped GITD powders, which have very long glow times - even up to 10 hrs for the green and aqua!! The blue lasts for around 8 hours and the red and purple for around 1 hour.
For those of you not aware of multimode diodes the output is bar shaped and very similar to the M140 diodes ie not a tight dot.
** Note to buy a completed laser you must be over 18 and own the correct safety goggles for your chosen wavelength. Please feel free to PM me for further details. **