Hello, Im thinking on buying this driver on my 2W m140 diode, the Mosfet is rated at 2 amps so ill have to use heatsink on it, but I asked seller and he said that soft start is about 40ms wich is kinda quick, my question is will it damage my diode ? And does this driver seems reasonably good quality for m140 diode ? Here the ebay link High Current LM358 Laser Diode Driver (445nm Diodes, Infrared and Red Diodes) | eBay
Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers
Buy Site Supporter Role (remove some ads) | LPF Donations
Links below open in new window
FrozenGate by Avery
40ms soft-start good for 2W ?
- Thread starter Shobos
- Start date
Sigurthr
0
- Joined
- Dec 11, 2011
- Messages
- 4,364
- Points
- 83
Considering diodes can be modulated much, much faster than that I'd say it is fine. Soft start is for the driver's benefit, not really the diode (unless you have a hell of a lot of inductance in your diode leads). Edit: I didn't check to see if the driver is fine for that diode, but the soft start is fine.
Last edited:
Thanks man ! The driver seems pretty decent, good soldering, proper fiberglass pcb, reverse polarity protection
rhd
0
- Joined
- Dec 7, 2010
- Messages
- 8,469
- Points
- 0
I note that they specifically say the MOSFET is rated for 2A, not the driver. You would want to see some margin. IE, a 2A driver should have a MOSFET capable of some reasonable margin more than 2A.
In other words, I wouldn't drive this board at 2A (or even 1.8A).
Further, as a linear driver, with fully charged cells, it may be dissipating as much as 6W. That's quite a bit.
IMO, we're at a stage where using linears for high current multi mode blue diodes doesn't make much sense.
In other words, I wouldn't drive this board at 2A (or even 1.8A).
Further, as a linear driver, with fully charged cells, it may be dissipating as much as 6W. That's quite a bit.
IMO, we're at a stage where using linears for high current multi mode blue diodes doesn't make much sense.
