- Joined
- Jul 29, 2015
- Messages
- 235
- Points
- 0
M140 445NM 2W Laser with Copper Heatsink.
Finally finished the build and popped In the batteries and it did turn out very bright and painful. The laser has a G2 lens and a M140 diode put inside, to go with the custom copper Heatsink for longer duty cycles!
Specifications
M140 with X-Drive in Copper module with Copper diode housing.
Custom host with copper Heatsink made by ehgemus.
Fits 2x 18350 batteries.
1.3 Hour per charge (definately need to be mentioned)
Duty cycle: 5Mins without too Hot.
G2 glass lens
Case POSITIVE
Custom host with copper Heatsink made by ehgemus.
Fits 2x 18350 batteries.
1.3 Hour per charge (definately need to be mentioned)
Duty cycle: 5Mins without too Hot.
G2 glass lens
Case POSITIVE
Pictures
Diode Module
NOTE: IF you are looking to build a laser, go DTR! 2-Day delivery and instant shipping!
Build Setup
-Soldering Iron
-High quality flux
-Laser host
-Laser module
-heatshrink tubing
-extra wires (incase)
-silicone grease (not needed)
-magnifying glass (not needed)
-Sponge (or something wet)
-Helping hands (not needed)
-An extra set screw (incase but VERY important)
-Allen wrench (mine is 4-40)
-something to drink (LOL)
-High quality flux
-Laser host
-Laser module
-heatshrink tubing
-extra wires (incase)
-silicone grease (not needed)
-magnifying glass (not needed)
-Sponge (or something wet)
-Helping hands (not needed)
-An extra set screw (incase but VERY important)
-Allen wrench (mine is 4-40)
-something to drink (LOL)
Note, In the first picture here I actually accidently shrinked the tube by putting too close to the iron (LOL) but I managed to get a new tube from the hardware store, unsolder the joints and slide the tube and connect again then shrink it! Also I bent the wrench too hard and broke the setscrew, I managed to get it out and buy a new one (4-40). That was close.
BeamShots
Note, MORE pictures will be added soon, I will also upload TONS of vids of it in action.
Last edited: