If you saw my previous thread, you know I have been working on building an Nd: YAG laser. It's completed now just as I go off to college. I don't have any pictures on this laptop so just watch the youtube video I made: https://www.youtube.com/watch?v=1Irr6munwdU
This project will not be completed until I determine how I will make a pumping chamber. I am pushing the lamp I have slightly, but this is not worrisome. Theoretically, I would only need around 8mJ of energy to reach threshold (If the system were 100% efficient, this means I need at least 8mJ...
I'm looking to start a project building a YAG laser. I do not know a few things though: what percent transmission output mirror to use, distance of the mirrors from the rod, size of flash lamp needed, and any information about the circuit needed to create the pulse (not looking to have pulses...
This is well-known I'm sure, but on the SXD, a wire is shown being soldered to the "enable" pin after removing a resistor. What should this wire be connected to? Any help will be greatly appreciated.
Thought I'd make a video of the NUMB08. For whatever reason the IPhone camera picks up the color as a bluish-violet. It's actually a lighter blue.
https://www.youtube.com/watch?v=8kESFa6cSlI
Thought I'd make a video of the NUMB08. For whatever reason the IPhone camera picks up the color as almost a violet color. It's actually a lighter blue.
https://www.youtube.com/watch?v=8kESFa6cSlI
I recently bought a NUBM08 laser module. When I supply power to it, it seems like the initial spot is slightly larger and brighter than it is after say a half a second after being turned on. I am thinking this is just how these drivers work, but I'm unsure and hoping this guy isn't slowly...
The hype is all over the blue, green, and violet lasers, neglecting the ol' red laser. I find the red lasers to be very amazing (the color and extremely thin beams of the single mode diodes) and I am trying to find the best diodes I could get my hands on (in terms of power, divergence, and beam...
I have been researching some of the dangers of blue light/lasers. Before I began researching this, I would often put my hand into the beam of the laser for brief moments until I felt a heating sensation/pinch (I would allow my hand to be in the beam for a maximum of 2 or 3 seconds, being very...
In building a driver circuit, how is the capacitor needed calculated? Also, how low in resistance can a potentiometer go? If I have a 100ohm potentiometer, what is the lowest resistance it can give? Thanks
I recently built a 1W+ blue laser. The diode I used is an Osram Pltb450b. My driver ideally outputs 1.25 amps, but I have run into a problem: the amperage dropping. I am using 6 AA batteries in series, and the amperage significantly drops after a total of 20 minutes of use (not one session)...