Sure did. Thanks again! I'm not very crafty with wood but the base is somewhat decent looking. High mode gets a little to warm for me but there is really no heatsink and its too bright anyway. Strobe will look cool on Halloween.
Closer you move it to the wall the smaller the shadow (obviously)
Anything really should work. It will be mounted close to the base of what I want illuminated so it can have any lenses on it needs to be as wide of beam as possible.
There should be a whole thread somewhere with the nightstand lamp.
looking to buy an LED and driver combo. I would like the die to be easily mountable by two screws. It will illuminate the following:
Needs to be wide angle to get the shadow effect.
What do you you have!?
Speedy.... I'm still here
I purchased one of the 18650 spacers from Mrcrouse last week and boy am I impressed. Its not much more than metal rod encased by plastic but it looks like something you would buy in the store (if you were buying dummy 18650s that is) This is much better than the half inch bolt with a whole roll...
Yeah it was returned to him to repair some threads on the front cap from a beam expander. All that has been fixed by Jack. Then the owner decided to sell it and instead of shipping it back out of country and possibly back into county it was held onto by Jack and sold onLPF. So when...
It has signs of normal wear. No scratches but there will be small imperfections. Nothing stands out unless you're looking for them.
Dot is perfect and tight. No artifacts.
I'm the second owner of it and I have put about 2 hours on it.
I have always run it far below duty cycle...
Re: Laser Projector and Quickshow! RPL-500
Per the manual:
638 @ 200mW
532 @ 150mW
450 @ 500mW
Air cooled with the exception of the dpss with has a TEC
Including the ILDA DB25 cable.
Was never able to measure the output of each color. The brains of the projector will...