That is basiclly my whole setup
Right now its just a bunch of dangling cables that I'm going to put inside a little box with a battery holder and a switch
I have an lpc-826 and everytime I turn it on it flashes brightly for half a second and then goes dim
Everything else is working fine its just the diode the amps are under control and everything
Did I kill it?
Im not good at soldering i absolutely suck
So ill just go ahead and buy the driver and just solder 4 cables on
But thanks
And with the two 18650s im done right?
I found this
Red laser IR laser diode driver 80-500mA
Details:
This Driver is for RED & IR Laser Diodes
Adjustable output
Constant current power driver 80-500MA
Size :10*20mm
TTL modulation 0-5VDC
2.5v laser on
Max Output: 2.5v, 500ma +/-
(808nm 250mw LD)
660nm 150mw LD
80-500mA
Input...
Where can i get an affordable 250ma driver?
I've tried making it but always fail (don't know which way the lm317 goes)
And will one 18650 li-ion battery power my lpc-826 at 150mw perfectly?
this?
I put the negative directly from the battery to the negative pin on the cable on the meter
Then i put the positive from the battery on the IN in the LM317 and then the positive pin from the meter on the last resistor
If this isn't what you mean sorry bout that i have no experience with...