Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

LPF Donation via Stripe | LPF Donation - Other Methods

Links below open in new window

ArcticMyst Security by Avery

Variable DC Power Supply - Which one?






jmgallego

jmgallego

0
Joined
Apr 9, 2008
Messages
374
Points
28
Bionic-Badger said:
Just get a cheap-ass one from China and build your own current regulators from transistors and your own circuits. Then you have ultimate control over your output and if you burn out your power supply, or it malfunctions, you won't affect your stuff.

I bought this one, but I'd probably buy some cheaper smaller ones if I knew what I know know. When I want to regulate current in a precise manner I just use a simple MOSFET based current regulator. If I were worried about the voltage stability I'd just put a linear regulator before it. All these secondary components are super cheap and do a great job.
Click to expand...

That looks even more doable!! Also, your suggestions make sense. As I mention on the original post, I am looking to an inexpensive one to test new laser diodes. But "we" are getting quite close to the 5A range, remember when we broke the 1A to drive our little babies? :yh:

Thanks guys for the great input.
 
Zeebit

Zeebit

0
Joined
Aug 27, 2012
Messages
1,110
Points
0
Gonna try and make my own bench PS. How much ripple is acceptable for general use?
 
The Lightning Stalker

The Lightning Stalker

0
Joined
Aug 14, 2013
Messages
2,655
Points
63
You could probably get away with ~30mV for everything except audio circuits, though it may trip up the
digital junk. For audio, <1mV.
 
Zeebit

Zeebit

0
Joined
Aug 27, 2012
Messages
1,110
Points
0
So if a 3A PS is going to have a ripple of 30mV(p-p) its going to take 0.8F of smoothing caps. That is a lot. Am I missing something?
 
Last edited:
djQUAN

djQUAN

0
Joined
May 27, 2013
Messages
1,154
Points
63
It's already regulated. What do you need the capacitor for?

Or are you asking about the bridge rectifier / capacitor before that circuit?
 
djQUAN

djQUAN

0
Joined
May 27, 2013
Messages
1,154
Points
63
I just used two 2200uF caps in parallel. Less could still have worked fine.
 
Zeebit

Zeebit

0
Joined
Aug 27, 2012
Messages
1,110
Points
0
Ah thanks. I was starting to think that I would need a bunch of 10000uF caps. Turns out even one will work.

Btw, you've got mail. I'm not trying to rush you because I know you're at work. :)

I'll rep you when I can.



For everyone else, sorry for derailing the thread.
 
Last edited:
You must log in or register to reply here.




Top