Making your AixiZ driver work. The solution!

the 80-500ma versions are perfect for phr-805t. Im running it @6V with 2 cr123 3V. tweeked the pot just a bit to get it to light, actually the pressure from the light screwdriver was enough to add +~10ma and the diode lit then i tightened it only slightly and i am getting a constant burning 405 beam, it produced a fair amount of heat, but with a little sinking its all good.

these drivers don't work for me... maybe I connected them bad... can anybody explain how exactly should I connect them?
I connected diode (+) to LD(+), diode (-) tried both, battery (+) to TTL (+), battery (-) to Power (-) TTL (-), didn't work at all