Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

LPF Donation via Stripe | LPF Donation - Other Methods

Links below open in new window

ArcticMyst Security by Avery

I have a problem with Micro FlexDrive setting

LBPark

LBPark

0
Joined
Feb 28, 2012
Messages
69
Points
0
I have a Micro FlexDrive

I want to use it up to 1A

but I can't understand picture in the manual

this

http://www.illuminalasers.com/ebay/MicroFlexDrive_V5_manual-2.pdf

What is the meaning of the yellow line?
 
Last edited:





Flaminpyro

Flaminpyro

0
Joined
May 4, 2009
Messages
5,443
Points
113
The yellow line is there where you would solder a piece of fine wire.

This will set the different current ranges.

So for 1000ma you would do what is in the 2nd picture from the right.

Solder a fine wire on the ends of the 3 resistors, don't get em too hot
or they will come off on your soldering iron, there tiny and don't have
much mass so be careful :)
 
Last edited:
LBPark

LBPark

0
Joined
Feb 28, 2012
Messages
69
Points
0
hmm......:confused:

So what I need to 1A should use?
 
Last edited:
LBPark

LBPark

0
Joined
Feb 28, 2012
Messages
69
Points
0
Oh, I did not see the last paragraph ...

thank you for your help
 
Flaminpyro

Flaminpyro

0
Joined
May 4, 2009
Messages
5,443
Points
113
No problem glad to help, try not using so much ketchup on your hamburger next time :crackup:
 
Last edited:
You must log in or register to reply here.




Top