Good Morning
Sorry but I'm very inexperienced,
I'm trying to configure the card flexmod p3 (interloock output loop monitor), but I can not operate the modulation by varying the voltage from 0 to 5v mod on the current and the output remains the same attention.
I connected a power supply 15v to V + and gnd, interloock to V + and the Mod to 5 volts arduino, reading the manual setup I run step 5 (Short the modulation input wires together and power on the driver, you should get to reading on your multi-meter of 50-
150mA. Adjust 0Bias until you reach the Desired standby current. Clockwise turns up the current, counterclockwise turns
it down.) and set the current 500, now I do not understand how I should connect to perform step 6 (A-short the modulation input wires and while Maintaining power to the driver apply to the Mod + 5V input and adjust
gain to the Desired maximum current. A clockwise adjustment Increases current.).
thanks 1000
Sorry for google translate
Sorry but I'm very inexperienced,
I'm trying to configure the card flexmod p3 (interloock output loop monitor), but I can not operate the modulation by varying the voltage from 0 to 5v mod on the current and the output remains the same attention.
I connected a power supply 15v to V + and gnd, interloock to V + and the Mod to 5 volts arduino, reading the manual setup I run step 5 (Short the modulation input wires together and power on the driver, you should get to reading on your multi-meter of 50-
150mA. Adjust 0Bias until you reach the Desired standby current. Clockwise turns up the current, counterclockwise turns
it down.) and set the current 500, now I do not understand how I should connect to perform step 6 (A-short the modulation input wires and while Maintaining power to the driver apply to the Mod + 5V input and adjust
gain to the Desired maximum current. A clockwise adjustment Increases current.).
thanks 1000
Sorry for google translate
