Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

LPF Donation via Stripe | LPF Donation - Other Methods

Links below open in new window

ArcticMyst Security by Avery

Boost Output Protection Explained






Joined
Jan 8, 2009
Messages
3,145
Points
83
Nice article, I almost made it through the third paragraph without wishing for a flexV8 with 2.2V to 12V input and up to 7V 4A output & aluminum board with built in heatsink connection points.

Seriously good article though.
 
Joined
Sep 20, 2008
Messages
17,622
Points
113
Yeah it's aimed at the new members that may not know
why their boost driver went into self-destruct...


Jerry

You can contact us at any time on our Website: J.BAUER Electronics
 
Joined
Dec 29, 2009
Messages
3,136
Points
63
TI has some great learning resources, just gotta sift through 'em all. Good find, Jerry :) Zeniers are one of my favorite components, but mainly because of the name and their weird personality. Always havin' breakdowns :p
 
Joined
Sep 20, 2008
Messages
17,622
Points
113
:thanks:
I posted it more for the detailed explanation of what
occurs and why when the output of a Boost Driver is
unloaded/open rather than showing a method of protection...


Jerry

You can contact us at any time on our Website: J.BAUER Electronics
 

Benm

0
Joined
Aug 16, 2007
Messages
7,896
Points
113
Putting a zener diode over the output is a good idea indeed, and will prevent blowing up the boost driver in case of a load disconnect. Adding the resistor may take some of the heat off the zener diode.

But in all cases it is important to consider the wattage rating of the zener diode and resistor. If you are boosting power for a 445 driven at 1.5 amps, your zener diode would probably be 7.2 volts or something in that order. Pushing 1.5 amps, that would result in a whopping dissipation of 10 watts, something a typical zender diode rated at ~1 watt will not survive for long.

If your boost converter has an enable pin, it would probably be better to detect the over-voltage condition and shut it down. It may power up again when the output caps charge drains, but will kick into protection as soon as the driver starts to ramp up the voltage again.
 

benmwv

0
Joined
Sep 10, 2010
Messages
1,380
Points
48
The resistor isn't to take heat off the Zener, it becomes the new sense resistor when current flows through the Zener. Make it a high value and the driver will regulate a few ma through the Zener, which it can handle all day.
 
Joined
Dec 29, 2009
Messages
3,136
Points
63
Sorry, I just had to comment on how I got a chuckle seeing BenM reply, and then another BenM reply.

zeener...
zeenyer...
zeen-eeyay?
 




Top