I must be reading some thing wrong I have a 445nm 1watt diode with the following operating specks (see below please!). I would like to operate this diode as close to its maximum out put as is practical. I have been looking over some of the most popular drivers, (micro boost, flex drive, etc) and none seem to be capable of operating at 1200 ma @ 4.3volts or am I just not understanding the specs of the drivers. I am a bit dense when it comes to electronics. I am how ever aware of the hazards of operating a high powered laser. Proper eye protection will be ordered before the driver.
I know this information must be available here on this forum but I am working a boat load of overtime right now and could use some direction please!
200 ma -- 23 mW* --* 3.7 Vld
300 ma -- 125 mW -- 3.8
400 ma -- 244 mW -- 3.9
500 ma -- 340 mW -- 4.0
600 ma -- 450 mW -- 4.1
700 ma -- 550 mW -- 4.1
800 ma -- 633 mW -- 4.15
900 ma -- 720 mW -- 4.2
1000 ma -- 820 mW - 4.2
1210 ma --1000 mW- 4.3
:yh:canceled my spyder arctic order!
I know this information must be available here on this forum but I am working a boat load of overtime right now and could use some direction please!
200 ma -- 23 mW* --* 3.7 Vld
300 ma -- 125 mW -- 3.8
400 ma -- 244 mW -- 3.9
500 ma -- 340 mW -- 4.0
600 ma -- 450 mW -- 4.1
700 ma -- 550 mW -- 4.1
800 ma -- 633 mW -- 4.15
900 ma -- 720 mW -- 4.2
1000 ma -- 820 mW - 4.2
1210 ma --1000 mW- 4.3
:yh:canceled my spyder arctic order!