luccax
0
- Joined
- Sep 6, 2010
- Messages
- 202
- Points
- 0
Hello,
I'm going to put one of my M140 on a C6 host i bought from DX:
C6 DIY Cree LED Flashlight Full Casing/Shell with Driver Pill (2*CR123A/1*18650) - Worldwide Free Shipping - DX
I'll probably buy an aixiz module heatsink from yobresal.
My doubt is about the driver, will this driver work?
5-Mode 1000mA 7135 Circuit Board for Cree and SSC Emitters - Worldwide Free Shipping - DX
Are there any other drivers of easy assembly around? Does a square driver (like X-drive) fits inside that aluminium cilinder with the positive contact of the battery under it?
That's all I need right? Diode+module+heatsink+Driver+C6+lenses ?
I searched a lot around but didn't found any tutorial on how to build a C6
I'm going to put one of my M140 on a C6 host i bought from DX:
C6 DIY Cree LED Flashlight Full Casing/Shell with Driver Pill (2*CR123A/1*18650) - Worldwide Free Shipping - DX
I'll probably buy an aixiz module heatsink from yobresal.
My doubt is about the driver, will this driver work?
5-Mode 1000mA 7135 Circuit Board for Cree and SSC Emitters - Worldwide Free Shipping - DX
Are there any other drivers of easy assembly around? Does a square driver (like X-drive) fits inside that aluminium cilinder with the positive contact of the battery under it?
That's all I need right? Diode+module+heatsink+Driver+C6+lenses ?
I searched a lot around but didn't found any tutorial on how to build a C6
Last edited: