- Joined
- Nov 6, 2014
- Messages
- 54
- Points
- 8
Not sure I would have to look at it. The 2.4A @ 8.4V will draw around 1.8A since it is a buck driver. The 1.8A would draw around 1.5A @ 8.4V.
There you go, my lesson for today
With the cut out bit, do you think it is the protection thing kicking in and by me removing power, am I bypassing the normal wait time?
Well, while I was writing this I think I maybe just answered my own question. I left the power on and it went into a pretty much 30 sec on / 30 sec off cycle without any further interference from me.
Anyway, off to work so I can afford another laser
Thanks
Mick
