Driver and laser assembly...

Ok hi guys.. just got all the parts I need to make my laser...

Parts list:

project box
heat sink
phr803t - blu ray laser diode (thanks scopeguy20)
flexdrive v4 - preset 110ma (thanks drlava)
Aixiz module
momentary switch
2x AA battery clips (holders)

ok all I need help with is wireing this bad boy up... how and where do I wire them to and any tips or suggestions when it comes to wireing and stuff....

Thanks -Adrian

i am going to assume you are very new to lasers my friend, i would suggest having someone help you who has built a laser(s) before.

it is not as simple as wiring it up.

even though your driver is PRE set... you still need to test it, i have recieved flexdrives that were 20Ma OVER what i had requested. thus killing my PHR at the time.

just a word of advice.

Oh, and you should DEFINATELY put this into a host. you have a flex drive and a heatsink. what kind of heatsink is it?

and did you press the diode into the aixiz module yourself? if so i hope you were veeeeery careful. if it is not set JUST right, your laser will be crooked and look horrible. or may not work at all.

PM me if you need any technical help. i wouldnt mind giving you a hand.

cool thank u I have recieved your helpful pm.

not a problem man, i'll never forget how many people helped me when i first got here.

i am simply "paying it forward"....thats a good movie BTW

Post some pics with some beamshots when your finished. Good luck on the build look forward to seeing it. op:

Jon