IsaacT
0
- Joined
- Aug 25, 2010
- Messages
- 5,947
- Points
- 83
Hey, so I have had issues with my MS-V4 hosts and decided my best course of action was to transplant my diodes over to some of Jayrob's Chrome Pen Hosts. Well, I thought I was doing my PL520 diode first, and it went very well. Everything went perfect, although when I tested it before putting everything in the pen it turned out to be my 450nm diode...no biggie.
So I went to go do my PL520 diode, and I got it out, but after grabbing my press and getting my next module ready I looked at the diode and to my horror there is now a big dent on the side of my diode can.
Nothing looks broken in there, but it is very much dented. Should I attempt to decan the diode or send it to someone else and see if they can? This is quite dissapointing to me but I am at that point in the hobby where I sort of just sigh really heavily, give the diode a moment(or two) of silence and then look at my budget to see if I can afford another. Unfortunately this is the most expensive diode I have ever owned and also now the 3.8mm Extractor tool is bent a bit on the top fragile edge. Luckily those were the only two diodes I had in pressfit module hosts but I just needed to vent a little bit and get this off my chest.
Any advice would be welcome but I have a feeling DTR will simply be getting more of my money. As per usual.
Thanks,
Isaac
So I went to go do my PL520 diode, and I got it out, but after grabbing my press and getting my next module ready I looked at the diode and to my horror there is now a big dent on the side of my diode can.
Nothing looks broken in there, but it is very much dented. Should I attempt to decan the diode or send it to someone else and see if they can? This is quite dissapointing to me but I am at that point in the hobby where I sort of just sigh really heavily, give the diode a moment(or two) of silence and then look at my budget to see if I can afford another. Unfortunately this is the most expensive diode I have ever owned and also now the 3.8mm Extractor tool is bent a bit on the top fragile edge. Luckily those were the only two diodes I had in pressfit module hosts but I just needed to vent a little bit and get this off my chest.
Any advice would be welcome but I have a feeling DTR will simply be getting more of my money. As per usual.
Thanks,
Isaac