1x 3.7v 10440 AAA powered. Pot modded to about 60mw (this is the older module with the bigger crystal)
1. Saw off the front of the Leadlight tube down to the back side of where the original button sat.
2. Tap new hole 44mm back from the new front end 90 degrees from the clip
3. Use needle files to form the hole into an oval the shape of the plastic button
4. Cut off spring from Leadlight module leaving the solder blob at the end
5. Insert module into the front aligning switch with new hole
6. Glue switch button back on
7. Insert 10440 battery (-) end first
8. Screw cap back on
9. Enjoy stubby pocket sized Leadlight
10. Reapply sticker to cover nicks and scratches from sawing process
Pics:
In action with no smoke added
1. Saw off the front of the Leadlight tube down to the back side of where the original button sat.
2. Tap new hole 44mm back from the new front end 90 degrees from the clip
3. Use needle files to form the hole into an oval the shape of the plastic button
4. Cut off spring from Leadlight module leaving the solder blob at the end
5. Insert module into the front aligning switch with new hole
6. Glue switch button back on
7. Insert 10440 battery (-) end first
8. Screw cap back on
9. Enjoy stubby pocket sized Leadlight
10. Reapply sticker to cover nicks and scratches from sawing process
Pics:
In action with no smoke added