Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

LPF Donation via Stripe | LPF Donation - Other Methods

Links below open in new window

ArcticMyst Security by Avery

Galvo speed clarification

GBD

GBD

0
Joined
Oct 25, 2010
Messages
783
Points
0
Hey all,

I am starting to make my very first X-Y scanner, and have got myself a pair of galvos to do it with.
I wanted to confirm that I understand what the specs mean, so the input of those more experienced then me would be appreciated.

The galvos have these ratings:

20 degree optical deflection
>20KPPS

15 degree optical deflection
>22KPPS

10 degree optical deflection
>25KPPS

8 degree optical deflection
>30KPPS

5 degree optical deflection
>35KPPS

Would this mean that at the respective deflection angle and speed, this is the maximum speed I can drive them at without overshoot?

or is it best to stick to one consistant speed for everything?

Thank you.
 





goninanbl00d

goninanbl00d

0
Joined
Jun 12, 2010
Messages
892
Points
0
GBD said:
Hey all,

I am starting to make my very first X-Y scanner, and have got myself a pair of galvos to do it with.
I wanted to confirm that I understand what the specs mean, so the input of those more experienced then me would be appreciated.

The galvos have these ratings:

20 degree optical deflection
>20KPPS

15 degree optical deflection
>22KPPS

10 degree optical deflection
>25KPPS

8 degree optical deflection
>30KPPS

5 degree optical deflection
>35KPPS

Would this mean that at the respective deflection angle and speed, this is the maximum speed I can drive them at without overshoot?

or is it best to stick to one consistant speed for everything?

Thank you.
Click to expand...

The speeds are given are the minimum speeds they are capable for a given deflection angle. Depending on what's being projected, the galvos may be able to be pushed further. (faster).

However, push them too far, and you risk damaging the galvos and amps permanently. It's best to stick to these given speeds for that purpose, though.

Also, in case you don't know already, if you need any lasershow-specific help, Photonlexicon.com would be the best place to look. :shhh:
 
E

ElektroFreak

0
Joined
Nov 7, 2008
Messages
5,725
Points
0
Ordinarily when a set of specs for galvos are drawn up the rated speed is determined at an 8 deg scan angle so if a set of galvos is spec'd at 20k, it's because they're tuned using a test pattern so that the pattern looks best at 8 deg. If you increase the scan angle you should decrease the speed proportionally. Failure to do so results in comparatively distorted imagery and in the worst cases possibly damage to the galvos.
 
GBD

GBD

0
Joined
Oct 25, 2010
Messages
783
Points
0
Thank you so much for clearing that up.
I will browse around on photonlexicon a bit too, I bet Ill gather a nice chunk of knowledge from there too.

TTerbo said:
did you buy THESE
Click to expand...

Yeah, those are the ones.

EDIT: for the speed, I was hoping to be able to do simple graphics without (or minimal) flicker, and maybe at the most, write short words (under 5 characters)
 
Last edited:
You must log in or register to reply here.




Top