Hi all,
I have a 50mW DX laser I plan to use as a telescope finder. I would like to take it apart so I can move the power switch to the telescope mount, and allow it to be continuously on for a few minutes at a time.
I could either replace the switch with a couple of wires leading to a new switch, or replace the back, or drill out the back, and replace with some sort of switch, then hold the main switch down with an o-ring.
I've tried unscrewing both ends by hand, no joy. Glued? I don't mind messing up the finish but I don't want to completely destroy it.
TIA
-- Rev
I have a 50mW DX laser I plan to use as a telescope finder. I would like to take it apart so I can move the power switch to the telescope mount, and allow it to be continuously on for a few minutes at a time.
I could either replace the switch with a couple of wires leading to a new switch, or replace the back, or drill out the back, and replace with some sort of switch, then hold the main switch down with an o-ring.
I've tried unscrewing both ends by hand, no joy. Glued? I don't mind messing up the finish but I don't want to completely destroy it.
TIA
-- Rev