Hi, I'm relatively new to the forum and I'm doing my first build. I picked up this 150-200MW Green Module and I'm trying to test it out before I star the build. The paperwork with the module says Positive Pole is the spring and negative pole is the brass body. Here's what I've done so far without any luck.
- For the positive I attached wire to the spring with the other end to the positive side of the battery.
-For the negative I attached another wire (using electrical tape) to the side of the brass body as per the paperwork and attached the other end of that wire to the negative side of the battery.
I got nothing from the laser. Again I'm just trying to test this thing out right now and don't currently have a host. I was just wondering if any of the pros on here could tell me what I did wrong if anything. Any advice on how to test this thing out would be much appreciated.
I should mention I'm using an 18650 battery. The laser module Specs say 3.7V-4.2V so I'm assuming this is appropriate.
Thanks!
- For the positive I attached wire to the spring with the other end to the positive side of the battery.
-For the negative I attached another wire (using electrical tape) to the side of the brass body as per the paperwork and attached the other end of that wire to the negative side of the battery.
I got nothing from the laser. Again I'm just trying to test this thing out right now and don't currently have a host. I was just wondering if any of the pros on here could tell me what I did wrong if anything. Any advice on how to test this thing out would be much appreciated.
I should mention I'm using an 18650 battery. The laser module Specs say 3.7V-4.2V so I'm assuming this is appropriate.
Thanks!