Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

LPF Donation via Stripe | LPF Donation - Other Methods

Links below open in new window

ArcticMyst Security by Avery

Has anyone worked with this host?






Joined
May 31, 2009
Messages
3,239
Points
63
Nope... but anything can be done. It should be easy enough as long as the inner dia is greater than 12mm
 
Last edited:
Joined
Feb 5, 2008
Messages
6,252
Points
83
Nope... but anything can be done. It should be easy enough as long as the inner dia is greater than 12mm
Well actually it'd had to be more than that if you're aiming for a heatsink for an Aixiz - you can't machine out aluminium foil and install a set screw in it.

If you're going for Direct pressfit heatsink, it doesn't really matter, inner diameter can be as low as 10mm, you only really need to fit the 9mm wide thread for the lens.
 
Joined
May 25, 2010
Messages
3,655
Points
0
This host has been worked or used before with memeber Qumefox in i think quit few different build. Also Ive worked on the 2x AAA one aswell.

The inner diameter of the host is smaller then 12mm. You will have to make a custom press fit heatsink or turn down an Aixiz Module.

However your driver of chose must be small. There is very little wiggle room in these hosts.

Good Luck.:beer:
 
Last edited:
Joined
Nov 27, 2011
Messages
65
Points
0
Awesome thanks guys! I was thinking of using a green o-like module:) And a 10280 battery. I just want to make sure i get a nice, snug fit for the module. And heatsinking would be nice. I ordered a few to play with, so I guess we will see.
 




Top