- Joined
- May 25, 2013
- Messages
- 534
- Points
- 28
Hey everyone, My 1st laser that got me hooked was starting to wear the anodising down so i decided to have a try at Blasting it with a crappy little sandblast gun,
I had a small 2hp Compressor so it was a slow painful process, I made sure to wear a Full face mask for my eyes/respitory!
Its just like how we TELL people to wear goggles when using lasers, well make sure you remove the battery and wear some sealed
eye protection atleast! if you are going to try something similar to what i done here
I only swept over the CREE and Aurora words, as i wanted to keep them on for now, I also gave it a solvent wipe with some Xylene before finishing up
Anyway i just thought i would share this with yous because i was quite proud after i finished, it helps hide scratches and dents better too!,
Hope yous Like!
I had a small 2hp Compressor so it was a slow painful process, I made sure to wear a Full face mask for my eyes/respitory!
Its just like how we TELL people to wear goggles when using lasers, well make sure you remove the battery and wear some sealed
eye protection atleast! if you are going to try something similar to what i done here
I only swept over the CREE and Aurora words, as i wanted to keep them on for now, I also gave it a solvent wipe with some Xylene before finishing up
Anyway i just thought i would share this with yous because i was quite proud after i finished, it helps hide scratches and dents better too!,
Hope yous Like!
Attachments
Last edited:
