C
carulli
Guest
I canot belive I did this but I did so now I need help. I decided to see if I could fix the button on my green 55mw laser as it was not working properly, so Itook the whole module out of the casing so I could get easy access to the curcuit board. The only way that I could get the switch back together was to use super glue. I tested tis and it all worked fine. I then put the module back in to the casing and while I was diong this I heard a pop, I just assumed it was the module slicking back into place. then I tried to fire it up and I got nothing. after an hour of trying to work out what was wron I realised there was a small black piece of plastic on the floor,so I looked at the circuit baord and realised it was a small diode or resistor that had broken in half!!!! So now to my question, will a drlava or rkcstr driver work to power this module? it is a WL 55mw laser.