Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

LPF Donation via Stripe | LPF Donation - Other Methods

Links below open in new window

ArcticMyst Security by Avery

Which DVD drive to harvest an open can?

Benm

Benm

0
Joined
Aug 16, 2007
Messages
7,896
Points
113
Indeed, doesnt look like something you'd be able to fit into a module. I guess you could still power it up and see what it does. Perhaps its doable to somehow mount it half into the 5.6mm hole of a module, keeping it in place with a bit of superglue.
 





Gazoo

Gazoo

0
Joined
Jun 9, 2007
Messages
3,206
Points
38
phenol said:
i pried loose the lite-on open can from its heatsink attacking it from the bottom side. there are several small indentures on the back of the heatsink where the diode base is---removing the glue there and pushing the base up with a small screwdriver symetrically on all sides should pop the diode out with little effort.
however: i read somewhere on LPF that the lite-on LD had the short-chip open can. I cant tell that for sure as im not able to see the chip of my specimen, but what i do know fora fact is that it has a higher voltage drop across the junction compared to my two LG diodes. The lite-on has 2.51V at 150mA, whereas LGs have 2.38V at 180mA. I dont know how this relates to output power handling/delivering capabilities of these diodes, but it is obvious that they are not identical.
Click to expand...

Well now this is getting very interesting. Since all you had to do was pry the diode up, very similar to how I did it with he Sony drive, the Lite-On might be a good pick after all. I don't know if mine had the long chip either. I do know the Pioneer and Sony drives have the same voltage drop, 2.83 running at 350ma's. And my SenKat diode has 3 volts across it running at 250ma's. So it is beginning to look as though the lower the voltage drop with a given current, the more powerful the diode is. This is why I hope we can get a voltage vs.current chart for the phasor diodes.
 
Benm

Benm

0
Joined
Aug 16, 2007
Messages
7,896
Points
113
Gazoo said:
So it is beginning to look as though the lower the voltage drop with a given current, the more powerful the diode is. This is why I hope we can get a voltage vs.current chart for the phasor diodes.
Click to expand...

I'd say that should hold true as a general trend, since higher power levels effectively require a 'bigger' diode (in terms of seconducting area) and hence a lower voltage drop for a given current.

The problem is in what determines how much power a diode can actually handle before it fails due to COD. This involves the properties of the facets on the lasing area, but it would make no sense to make an excessively large lasing area when its facets are not capable of reflecting the light it produces around.

In that respect i dont think open can diodes will perform better then closed cans per se (apart from the loss in the window), but it seems like newer, more powerful, diodes are produced as open cans in many cases. I reckon this has more to do with cutting cost than with having a can or not.
 
Kenom

Kenom

0
Joined
May 4, 2007
Messages
5,629
Points
63
Well, regardless of the packages that are going to be available, I'll be there to provide a barrel and housing. I did suceed in getting that rectangular monstrosity mounted and it worked for a short while.
 
S

scanna

0
Joined
Jan 17, 2008
Messages
6
Points
0
Hello fellas !!
I bought and open an LG 20X dvd burner and i found as follows:
- an open can red wich i think will be easy to extract from the heat sink housing
- another IR (nearly visible) wich is more difficulty to take out from
They both burn !!!!
The red is very bright and i think will be something above 250 mW
I didn t make any test i am waiting an aixiz module end a circuit to drive it.....
will post again when everything will be assembled and tested.
have a nice day!
 
G

goldfingerfif

0
Joined
Feb 2, 2008
Messages
259
Points
0
Kenom said:
well, I'll tell ya one thing for sure.  STAY AWAY FROM SAMSUNG DRIVES.  weird square diodes that look like this :



PIC_0002.jpg
Click to expand...


My brother bought some Samsung DVD burner and he doesn't know where the diode is and niether do I! It looks kinda like your pic above, looks like there might be 2 diodes. Everyone stay away from Samsung.

02092008018.jpg
 
You must log in or register to reply here.




Top