Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

LPF Donation via Stripe | LPF Donation - Other Methods

Links below open in new window

ArcticMyst Security by Avery

WTB: cr2 charger

Joined
Feb 5, 2008
Messages
6,252
Points
83
i have two, one is a uni from modwerx, the other(one mentioned) is a ultrafire WF-138 switching charger(charges both 3.0 and 3.6v) for CR123s. so i can use a small magnet to fill the space? that sounds like a good idea, thanks man.
It is perfectly OK to use magnets to fill space for CR2s , however only on CR123s and similar smaller capacity batteries (3V, not 3.7V)

Don't try something like that with 18650 charger that provides 1 A charging current, with smaller 16340 or 10440 batts.
Charging current must always be UNDER 1C of a battery.
CR2s are around 500-600mAh if I am not mistaking?

All of them say 800 but I think it is overrated greatly, I have a pair of those but not the charger, so I cannot test those.
I will most likely pick up a $7 charger+ 2pcs batts from O-like next time I order from them.
I have to test the capacity of those I have.
 





Joined
Oct 7, 2009
Messages
1,053
Points
48
My CR2s are now charging nicely in my CR123 charger! +1 for the advice, you saved me at least $5, and some waiting.
used the small magnets from a GGW sled!:D


EDIT: @OP, if you want that module end, PM me your shipping address so i can send it out
 
Last edited:
Joined
May 16, 2009
Messages
134
Points
0
I apprreciate all the help you have given me! i would have bought another charger or primary batts if i didnt know you could just use some small magnets!!! thanks!!
 
Joined
Feb 5, 2008
Messages
6,252
Points
83
No problem folks, that is what this forum is for = helping each other out!

Enjoy!
 
Joined
Oct 7, 2009
Messages
1,053
Points
48
Jake, your aixiz module end was shipped out to you today! Enjoy, and good luck with your builds!:san:
 




Top