Kenom
0
- Joined
- May 4, 2007
- Messages
- 5,629
- Points
- 63
I'm getting rid of all my laser related goodies in preparation of leaving the forum. it all must go and I'm not going to make a penny on any of it. I want out and don't wanna deal with it any more. So, if you want it, it's yours for the cost of shipping alone.
first up:
Heatsinks purchased for the Kenometer Thermopile. These are designed to fit on the sides and increase thermal efficiency. I never got around to finishing the project. You can fit four around the periphery. top, bottom and sides. I have a total of 45 of these. However many a person wants is however many a person gets. Shipping is $5.95 for a flat rate box inside the con/us and $14.95 outside.
(GONE)
Next is fuse and fuse holders.
I have 5 of these. Same as above. No cost but shipping.
Power supplies. These have 5v, +12v, -12v and all operate on 120/220v wiring diagram is here:
I have 2 of these.
power connectors for the psu
I have a total of 4 of these.
Potentiometers with all the required hardware including knobs. (GONE)
value is unknown at this time and honestly I couldn't care less. They are free and I'm not going to take the time to measure them.
Rocker switches. These are fairly big so don't get one if your need is for small.
(GONE)
Combine multiple things in one box is a good idea to save on shipping. To give you an example. Say you want 1 psu, 1 fuse holder, 1 power plug, 1 switch, and 4 heatsinks. Your total cost in shipping would be $5.95 con/us or $14.95 international.
Most of these components were for meter related stuff. They are perfect for powering a thermopile that requires +/-12v as well as 5v for a panel meter. Fuse to protect it, power plug to get power to it, and an on/off switch. Since I will never be building another meter and never plan on taking anyones money off this forum again, they have to go free.
first up:
Heatsinks purchased for the Kenometer Thermopile. These are designed to fit on the sides and increase thermal efficiency. I never got around to finishing the project. You can fit four around the periphery. top, bottom and sides. I have a total of 45 of these. However many a person wants is however many a person gets. Shipping is $5.95 for a flat rate box inside the con/us and $14.95 outside.
(GONE)
Next is fuse and fuse holders.
I have 5 of these. Same as above. No cost but shipping.
Power supplies. These have 5v, +12v, -12v and all operate on 120/220v wiring diagram is here:
I have 2 of these.
power connectors for the psu
I have a total of 4 of these.
Potentiometers with all the required hardware including knobs. (GONE)
value is unknown at this time and honestly I couldn't care less. They are free and I'm not going to take the time to measure them.
Rocker switches. These are fairly big so don't get one if your need is for small.
(GONE)
Combine multiple things in one box is a good idea to save on shipping. To give you an example. Say you want 1 psu, 1 fuse holder, 1 power plug, 1 switch, and 4 heatsinks. Your total cost in shipping would be $5.95 con/us or $14.95 international.
Most of these components were for meter related stuff. They are perfect for powering a thermopile that requires +/-12v as well as 5v for a panel meter. Fuse to protect it, power plug to get power to it, and an on/off switch. Since I will never be building another meter and never plan on taking anyones money off this forum again, they have to go free.
Last edited: