Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

LPF Donation via Stripe | LPF Donation - Other Methods

Links below open in new window

ArcticMyst Security by Avery

Dual PHR hookup to FlexMod help needed

Joined
Oct 20, 2007
Messages
128
Points
0
I know there are a few of LPF members that have successfully hooked up two Phr's to Flexmod. I'm hoping that they are willing to share their setup with me. Dr Lave posted his recommendations on PL in reference to 3 volt reds but i was unable to find anything with regards to the PHR's. What I need is the formula or maybe exact setup to get 90 to 130ma draw on each one. I originally came up with a 1 ohm balance resistor but that doesn't sound right. I'm gonna use a 4 ohm for the reds but not sure with the PHR's. Can someone give be some ideal on what to use?
This is the setup I'm using....
Chuck

dual-diode-connection.jpg

dual-diode-mount.jpg
 





Things

0
Joined
May 1, 2007
Messages
7,517
Points
0
Those are some nice heatsink assemblies! I was just mucking about with ohms law, 40 ohms? I have no idea, contact Lava directly and see what he says :)
 
Joined
Oct 20, 2007
Messages
128
Points
0
I probably should..I posted this on PL but didn't get any response with regards to the PHR's... I think he's a busy guy...I sent a msg to him awhile back (different subject) but never got any answer.
Maybe someone here will see this later on....
Thanks anyway:)

Chuck
 




Top