- Joined
- Mar 29, 2013
- Messages
- 2
- Points
- 0
Hey guys,
Where to begin.....Well, i finally found out how to register after roughly 10mins of searching :shhh: talk about blind (not from lasers though) haha.
Second, after extensive research, I've finally found out what type of first laser I would like. The PL-E v3 600mW 532mW laser from Jet laser, I hear the customer service it one of the best out there. And yes I'm going to get GOOD safety goggles (and always wear them while the laser is in operation while inside), never aim the beam at people, planes, animals or reflective surfaces and use my common sense as to avoid common mistakes made. I've read many posts about laser safety, accidents and general knowledge that has made me aware of the dangers.
Finally, my question. On the Jet lasers site, the beam divergence for the 532mW is 2.0mrad, now that seems kinda bad for a high quality laser, however the lens is adjustable which means the divergence would change, but would adjusting the lens increase the divergence or the beam diameter or both (2.5mm adjustable)?
Thanks for your time
Where to begin.....Well, i finally found out how to register after roughly 10mins of searching :shhh: talk about blind (not from lasers though) haha.
Second, after extensive research, I've finally found out what type of first laser I would like. The PL-E v3 600mW 532mW laser from Jet laser, I hear the customer service it one of the best out there. And yes I'm going to get GOOD safety goggles (and always wear them while the laser is in operation while inside), never aim the beam at people, planes, animals or reflective surfaces and use my common sense as to avoid common mistakes made. I've read many posts about laser safety, accidents and general knowledge that has made me aware of the dangers.
Finally, my question. On the Jet lasers site, the beam divergence for the 532mW is 2.0mrad, now that seems kinda bad for a high quality laser, however the lens is adjustable which means the divergence would change, but would adjusting the lens increase the divergence or the beam diameter or both (2.5mm adjustable)?
Thanks for your time