What kind of heatsinks would you guys recommend for a knife edge array setup for a long duty cycle?
For 12mm modules I found this design:
http://i.ebayimg.com/00/s/MTA2NlgxNjAw/z/JpcAAOSwyZ5UmQRv/$_57.JPG
But its not easy to attach a fan to it when needed.
There's also this design, and it has screws on the back for screwing a fan, but I only found 13mm of these, no 12.
http://i.ebayimg.com/00/s/MTA2NlgxNjAw/z/HcMAAOSwAL9UkViJ/$_57.JPG
For 12mm modules I found this design:
http://i.ebayimg.com/00/s/MTA2NlgxNjAw/z/JpcAAOSwyZ5UmQRv/$_57.JPG
But its not easy to attach a fan to it when needed.
There's also this design, and it has screws on the back for screwing a fan, but I only found 13mm of these, no 12.
http://i.ebayimg.com/00/s/MTA2NlgxNjAw/z/HcMAAOSwAL9UkViJ/$_57.JPG