Recent content by SmittyMC

that is a good point i was mainly thinking of the capacity not the mA output with the driver and load in place.

this is quite an engineering masterpiece i like how the head was milled out to fit your heat sink and then made to accept your focusing module. now with reference to your circuitry you have two laser drivers in parallel were they both wired on the one PCB or did you only show one in your pics?

keep in mind that capicators take up to 6 times as long to fully charge than to disscharge. like mentioned above a mosfet circuit could work well. and calculating the amount of V and I output from the cap to the diode so you are to not over drive it in watts or mW.

hi all i am kinda new to this forum and have built my own diy laser in the past. i do have a backround in electronics and was wondering if anyone has thought of making a High output laser ie 1w+ and using a Maglite or simmilar flashlight as a shell. i have two mag's and one is a 4D the other a...

Hi i have been reading this forum for the past few days and doing my own research and you guys have blown me away with your knowledge and understanding of the topic of lasers. so i decided to join and perhaps soak some of it up.