Hello,
I'm trying to finish my M140 build on a C6. I'm using a DX driver as seen on the pictures.
My doubt is, can I only connect the + out and - out of the driver to the diode and put that little solder point there to connect the case to the driver negative input?
The diode white wire won't...
I'm looking for buying this AW IMR 16340 batteries. About 10 of them.
Where can I buy it?
(It may be another brand battery, as soon as they can handle powering a 2W 445nm laser wich ultrafire doesn't)
I know he is a member of the forum. I'm sure he is a great guy and very serious on his work, but shipping to Brazil is much quicker from china then USA also.
I tought their C6 came with Survival mark...
I like them naked too but I had a very bad experience buying from survival.
They ship on a box instead of envelope (two c6 heatsinks and two buck drivers, could easily fit an envelope). Boxes take much longer to arrive and are much more expensive.
:crackup:
I have a laser solution for you. Grab a lithium battery, crack it open and drink just a little bit of the lithium inside.
Lithium carbonate is the ultimate treatment for schizophrenia
I'm using a buck driver, it's not that AMC7135.
I was affraid the diode might be dead and I hooked it up to my PSU, it lights very weak and don't go over 200mA.
I'd better post a video. I turn the laser on and it starts to become weaker, power drops really quickly until it looks like a 5mw pen in about 10-20 seconds.
When I get home i'll upload it.
I sell my builds at my family's retail store, I must spend the lowest on the builds.
Is there any site where I can buy 20 of this cells with discount? I can't find any