DTR
0
- Joined
- Jun 24, 2010
- Messages
- 5,684
- Points
- 113
Take a picture of what you did.
Sure no prob. definitely looks like i bridged the correct side.
Pot side https://www.dropbox.com/s/m5xm1j15bzfdyn3/potside.jpg
Resistor side https://www.dropbox.com/s/w2m5lyvr5135obo/resside.jpg
I know it looks sloppy, but i only have a blunt tip soldering iron right now that is SUPER hard to use. I am 95% sure they are bridged correctly. Maybe i broke the pot? I don't know, what causes the output to freeze like that?
At 1.8A do these need heatsinking? they are amazingly small, and i imagine they would be hard to HS
You sir are amazing! +rep Where can i buy those, with Mohgasm LLC and Cajunlasers gone i have no idea where to buy good drivers like those.
EDIT: it wont let me rep u atm i will later when it lets me
Looks like the rectangular boards are sold out everywhere now! :/
Correct me if I'm wrong please. I need a few of those suckers.
That's awesome news :wave: keep it up mate :beer: