Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

LPF Donation via Stripe | LPF Donation - Other Methods

Links below open in new window

ArcticMyst Security by Avery

how it works TTL?

T

trawen

0
Joined
Oct 16, 2013
Messages
24
Points
0
I have driver for blue laser.

$T2eC16NHJHwE9n8ig+Y!BQsiwIeVjg~~60_3.JPG


$T2eC16JHJGwE9n)ySdEoBQsiwLzHuw~~60_3.JPG


how to control the TTL?

Initially, the laser lights. If close contact TTL it off. But I'm not sure what I should do. Post on ground TTL or apply +5 volts?

(for that would turn off the laser)

The laser is used to show and TTL flashes through it stronger or weaker the heat?
 





T

trawen

0
Joined
Oct 16, 2013
Messages
24
Points
0
That is, there is the pull-up resistor?

(See the track from the TTL through a resistor 102 to the transistor)
 
MarioMaster

MarioMaster

0
Joined
Jul 27, 2007
Messages
3,642
Points
63
This is typical for chinese made drivers, it lets them use the same driver for lasers that do not have any control systems. There is a pullup resistor that keeps the laser on with floating input (this is normally considered unsafe so most higher quality laser systems have pulldown resistors to turn the laser off with no signal)
 
You must log in or register to reply here.




Top