Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

LPF Donation via Stripe | LPF Donation - Other Methods

Links below open in new window

ArcticMyst Security by Avery

Heatsinking the Groove 2

Joined
Dec 17, 2010
Messages
1,144
Points
48
Hey everybody. I'm putting together a LPC-815 right now, and I'm using one of the Doc's Groove 2 drivers. He's not the best with answering questions promptly, so I figured I'd ask here after searching the forum thoroughly.

What components on the groove need to be heatsinked? I have a flat driver sink milled out in the sink for the host. I was just going to use some Arctic Silver epoxy to set it there.

Thanks! :D
 





Joined
Dec 17, 2010
Messages
1,144
Points
48
Sweet! I'll probably be running around 400ma, but I think I might be putting one of scopeguys lpc-826's in later on. I figured it was best to heatsink anyway. Plus, I need to epoxy it to the driver mount anyway. Thanks DTR! :san:
 




Top