Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

LPF Donation via Stripe | LPF Donation - Other Methods

Links below open in new window

ArcticMyst Security by Avery

D Cell Battery Capacity

Joined
Jun 20, 2013
Messages
530
Points
0
I'm going to be doing a build with Mrcrouse's 2D Maglite and i'll be using an x-boost set at 1.8A with either a m140 or a 9mm 445nm diode. Will two 1.5V D Cells be enough to boost off of? I researched the capacity and a few websites said each cell has 14000mah which is beyond what I need, but as far as the potential difference, will 3V be enough? Thanks:beer:
 





Joined
Feb 18, 2013
Messages
744
Points
28
You mean standard alkaline D batts? They might work, but I doubt you'll get full power with those. Standard alkaline aren't the best at high current drain.

Lithium D cells would work much better, but finding a li-ion equivalent would be the best option.
 
Joined
Jun 20, 2013
Messages
530
Points
0
Yes, they are alkaline (not li-ion) batteries. I'll try the alkaline ones and see how much power they put out when the build is finished
 

Benm

0
Joined
Aug 16, 2007
Messages
7,896
Points
113
One very important thing to notice with alkaline batteries is that their voltage drops quickly with discharge, especially under heavy load.

They could well be rated 14 Ah, but that figure is normally achieved under low load conditions (discharge current of 1.4 A or even less), and with a cut-off point of 1 or even 0.7 volt per cell.

The latter could be a big problem if you need the voltage: If your driver has, for example, a minimum required input voltage of 2.5 volts, you'll only get a fraction of that 14 Ah out off the cells before the voltage drops too low. You can still use the cells after for something less demanding*, but you will have much shorter runtimes that you'd expect when calculating with the 14 Ah figure.

* say, to power an ordinary maglite with incandescent bulb which will light for a long time, albeit ever more dimly.
 
Joined
Jun 20, 2013
Messages
530
Points
0
Okay, so It sounds like I should just switch to Li-ion cells. Is there a way of managing that with a voltage between 3V to 5V? I may just have to resort to a battery spacer.
 

Benm

0
Joined
Aug 16, 2007
Messages
7,896
Points
113
Its probably best to use a spacer if your driver cannot handle over 5 volts.
 




Top