Blowing diodes left and right

Lotus_Darkrose said:

The title of this thread made me laugh. A lot. That is all. (Sucks about the diodes though)

Click to expand...

Lol. Me too.

I have had issues with lava's drivers as well. His response was basically get another one...
I (might have) found a replacement for the flexmod but nothing as compact as the flex v5

bobo99 said:

Edit: well already failed the continuity test between the heatsink, and the driver output...(something I will always check for from now on). Now to figure out how to remove this cement somehow..

Click to expand...

Your short problem is not the Arctic Silver Epoxy... we use it exclusively
to thermally bond our Thermopille sensors to our heat-sinks and the
small bare wires from the sensors are normally in contact with the Arctic
Silver Epoxy and have never been a problem.

We have tested the cured Arctic Silver Epoxy on the 20 MegOhm
scale of our Fluke DMM and get no resistance readings with a
distance between probes of <1/16"... It is an open circuit..

You probably have a direct PCB or wire contact where you Epoxied
your FLexDrive.

rocket689 said:

I try to use a thick amount of Arctic Silver epoxy and hold it away slightly until the adhesive sets.
Then test continuity.

Click to expand...

Good advice....


Jerry