Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

LPF Donation via Stripe | LPF Donation - Other Methods

Links below open in new window

ArcticMyst Security by Avery

50A CC Linear Driver?

Wolfman29

Wolfman29

0
Joined
Jan 14, 2011
Messages
3,816
Points
63
Hey everyone -

So I am in the works of getting the 40W 808nm diode bar working... and basically, I need a 50A linear driver. Heatsinking won't be an issue, and I will have a stable voltage just above the linear driver's threshold voltage.

BUT. I can't seem to find anything that will run more than 10A or so. I think that I could use a bypass transistor in an LM317 type circuit, but my sims show it won't work :thinking:

Anyway, I'd appreciate any help any of you guys can offer.
 





Sigurthr

Sigurthr

0
Joined
Dec 11, 2011
Messages
4,364
Points
83
You could parallel 50 LM317T's XD. That would be a sight to see!
 
Cyparagon

Cyparagon

0
Joined
Sep 12, 2007
Messages
9,399
Points
113
A typical op-amp current sink similar to this is almost infinitely scalable
 
Last edited:
Hiemal

Hiemal

0
Joined
Dec 27, 2011
Messages
1,443
Points
63
Meatball said:
^^Are those circuits better with MOSFETs or darlingtons?
Click to expand...

With a mosfet it would have very very low dropout voltage, since a mosfet doesn't have a voltage drop, but an on state resistance instead. Plus MOSFET's are also easier to find in higher current capability ratings.
 
Last edited:
Cyparagon

Cyparagon

0
Joined
Sep 12, 2007
Messages
9,399
Points
113
^They only behave like that when driven in saturation, which offers no control over the current and isn't applicable here.

Sure, you can find mosfets in much higher currents, but, again, it doesn't apply here. You'll need a volt or three of headroom for either, and so the limiting factor is power dissipation. This value often depends on the case type rather than the transistor type.

Mosfet would be slightly more efficient because there's no drive current while BJT is more stable, but you'd have to build a pass bank no matter your choice.
 
Wolfman29

Wolfman29

0
Joined
Jan 14, 2011
Messages
3,816
Points
63
I think I am going to go with the circuit Meatball linked. Thanks!
 
Benm

Benm

0
Joined
Aug 16, 2007
Messages
7,896
Points
113
As far as the opamp circuit being scalable: It is, but it does require the use of an additional transistor (in a darlington construction) to have sufficient gain. With plenty of supply voltage it can be used directly by replacing the BD139 with a (bank of) suitable mosfets.

There is the practical problem of the sense resistor though: you should scale that way down along with the rest of things. If you are looking at 50 amps, the replacement for the resistor would probably have to be a length of wire rather than something you can buy as a component.
 
Cyparagon

Cyparagon

0
Joined
Sep 12, 2007
Messages
9,399
Points
113
75mV might not be high enough of a signal to regulate properly. A difference of 500mA through it would only be a difference of 750µV for example which is lower than the noise you might see in the circuit.
 
You must log in or register to reply here.




Top