- Joined
- Jun 21, 2012
- Messages
- 2,019
- Points
- 48
Ok so I recently bought 2 C8 from fasttech, one was suppose to be for a red LED from a projector the other for the MRcrouse Heatsink GB. well for now I've ditched the red LED build for now as I had these parts laying around to make this build happen, so that's what I did. So the parts I used where a C8 host, a XM-L2 emitter on a 20mm Star, East-092 Driver!
Sorry about the quality I usally use my DSLR but didn't have the time to get it out well doing the build so I just used an Iphone 4 that I had laying around.
First I started by breaking it down.
Here is the original driver and emitter.
Little baby emitter.
New emitter and driver.
Pill after getting the emitter off. pretty decent side.
back side.
Now you might notice the 20mm star doesn't quite fit in there perfectly so I shaved it down a bit on the sides to get a nice tight fit. this was just before adding the Artic aluminum.
Driver with the spring added.
All complete
Polished the Bezel!
After Glow Ring!!
So this this is pulling 3.65A at the tail cap on high with a NCR18650B cell. and the best part its direct drive in high but still retains its 5 modes.
Thanks For looking!!
Sorry about the quality I usally use my DSLR but didn't have the time to get it out well doing the build so I just used an Iphone 4 that I had laying around.
First I started by breaking it down.
Here is the original driver and emitter.
Little baby emitter.
New emitter and driver.
Pill after getting the emitter off. pretty decent side.
back side.
Now you might notice the 20mm star doesn't quite fit in there perfectly so I shaved it down a bit on the sides to get a nice tight fit. this was just before adding the Artic aluminum.
Driver with the spring added.
All complete
Polished the Bezel!
After Glow Ring!!
So this this is pulling 3.65A at the tail cap on high with a NCR18650B cell. and the best part its direct drive in high but still retains its 5 modes.
Thanks For looking!!