Uhoh

MY LASER BROKE :wtf: Ok first of all lately (past 2 weeks) I have been noticing that on infinity the laser was unfocused (like a focal point a yard or so away from the laser) and the focusing ring was as tight as it could be so I figured the diode assembly had moved back for some reason and started storing my laser standing up hoping gravity would fix it but it just got worse, today the focal point was 6 inches from the laser as focused as I could get it so I figured I might have to switch host's and I was burning stuff then unscrewed it to check if I can see if the diode housing moved and noticed the wire from the batts to the driver came off and I do not have a solder and I don't know how to get the driver, heatsink, and diode out without breaking it, I have always followed the duty cycle :scowl: any idea on how I can fix it ? I do know someone with a solder but I think I should just change host's, I will take pics later my dad has the camera and is not home right now
p.s. It is the Lazerer Stick as seen in my sig
p.s.s. I have had it for 2 months and use it on average 3 times a week for 10 mins each time.(following duty cycle of course)
p.s.s.s. I contacted Max a few minutes ago but the warranty is only 1 month. :cryyy:
p.s.s.s.s. The diode housing does look like it moved back but idk I might be wrong
p.s.s.s.s.s. I am interested in selling it, it worked perfect before the wire came off, it may need a new host unless it will only be used for burning or u can somehow fix the focusing problem

Find a member in your area and ask them to look at it for you, it could be an easy repair. Can't say much more without photos of the damage.

ARGLaser said:

Find a member in your area and ask them to look at it for you, it could be an easy repair. Can't say much more without photos of the damage.

Click to expand...

Well the wire may be easily soldered but there still is the focusing problem :/

brendon7358 said:

Well the wire may be easily soldered but there still is the focusing problem :/

Click to expand...

Well, if the diode module did just move back a bit, it shouldn't be hard to put it back to it's original position and use some thermal epoxy to hold it in place.

ARGLaser said:

Well, if the diode module did just move back a bit, it shouldn't be hard to put it back to it's original position and use some thermal epoxy to hold it in place.

Click to expand...

I tried pushing on it gently but it won't budge :undecided:
this is a pic from a previous thread when it worked .
This is a pic I took with my phone now

Here are some better pics:

Did you splice in a piece of wire with tape or something?:thinking:

Ozzy357 said:

Did you splice in a piece of wire with tape or something?:thinking:

Click to expand...

No it was like that when i got it :undecided:

Can't you just push it back into position using a vise or something similar?

It probably won't budge when just pressing it with your hands, but some extra force can do miracles.

Benm said:

Can't you just push it back into position using a vise or something similar?

It probably won't budge when just pressing it with your hands, but some extra force can do miracles.

Click to expand...

Wouldn't a vice risk snapping the driver? or is there a way to go around the driver? If you can push it forward and resolder the wire back on I will give you a 50mw 532nm module and cover the shipping cost's