- Joined
- Dec 30, 2016
- Messages
- 1,410
- Points
- 0
I've been messing around using a IR temp gun and having all the focusing part removed from the laser, with everything removed the brass heat sink fits perfectly in the temp guns opening. I just wanted a way that could tell me quantifiable that the power output was def dropping and when it was dropping off.......
Ok this is what it's doing, For about 15 to 20 seconds the temp gun reads 200 degrees and then after around 15 to 20 seconds it starts to drop very rapidly and at 50 to 60 seconds it by around dropped by half and yet nothing is warm to the touch, A few minuets later I repeat the test with the same batteries and I get the same results, A few minuets later I repeat the test with the same batteries and I get the same results, A few minuets later I repeat the test with the same batteries and I get the same results. and the whole time nothing is even warn to the touch ?
Well you get the idea........
That would pretty much have to be the driver issue wouldn't it ?
Ok this is what it's doing, For about 15 to 20 seconds the temp gun reads 200 degrees and then after around 15 to 20 seconds it starts to drop very rapidly and at 50 to 60 seconds it by around dropped by half and yet nothing is warm to the touch, A few minuets later I repeat the test with the same batteries and I get the same results, A few minuets later I repeat the test with the same batteries and I get the same results, A few minuets later I repeat the test with the same batteries and I get the same results. and the whole time nothing is even warn to the touch ?
Well you get the idea........
That would pretty much have to be the driver issue wouldn't it ?
Last edited: