- Joined
- Jun 19, 2010
- Messages
- 66
- Points
- 0
Hi all.
Has anyone here ever tried to cut Kevlar with a 445nm laser or LD based laser before? A friend of mine is looking to cut 3/16 panels and would like to know what minimal power would be required to do this.
He wants to avoid using IR for its inherent dangers and a bulky Co2 tube is out. Would 1W-1.5W be enough for the job?
Speed is not an issue, but depth is. I have noticed with my 445 that it cuts quite deep depending on material and focus.
Any suggestions welcome.
Has anyone here ever tried to cut Kevlar with a 445nm laser or LD based laser before? A friend of mine is looking to cut 3/16 panels and would like to know what minimal power would be required to do this.
He wants to avoid using IR for its inherent dangers and a bulky Co2 tube is out. Would 1W-1.5W be enough for the job?
Speed is not an issue, but depth is. I have noticed with my 445 that it cuts quite deep depending on material and focus.
Any suggestions welcome.