Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

Buy Site Supporter Role (remove some ads) | LPF Donations

Links below open in new window

FrozenGate by Avery

CLOSED - Osram PL TB450B 1.6W (Substitute for the M140)

Re: Open: Osram PL TB450B 1.6W (Not M140)

POLISHEDBALL said:
Did you run any secondary correction lens or just the collmenating lens?
Click to expand...

No. Just used a 405-G-1 lens. I do have a cylindrical lens but I don't think it will be suitable for this diode.
The raw output (no lens) is different but with a lens on it, the profile looks about the same.

shokkunlasers said:
So this diode is basically a cheaper alternative for the m140:)
Click to expand...

Yeah I guess you could say that.
 





Re: Open: Osram PL TB450B 1.6W (Not M140)

cheech226 said:
@mhemling33 what did you think of the beam with the g2 compared to an m140 diode?
i'm on the fence here. a very well known diode against the new guy. i can only buy one.
Click to expand...

To tell you the truth I think it is about the same. I try to take some comparison shots and post them in a little bit.

One thing I have noticed when you compare the outputs without lenses.... the Osram is thinner but longer then the m140.

I am glad I got one if I had more funds I would grab another.
 
Re: Open: Osram PL TB450B 1.6W (Substitute for the M140)

If you look at the raw output it looks almost identical to the PL TB450 and it is safe to say it is not an m140 diode.

Osram PL TB450B



Osram PL TB450


Ka$io M140


It's hard to take a picture of but here is my attempt showing the batwing to one side.
 
Re: Open: Osram PL TB450B 1.6W (Substitute for the M140)

That batwing is usually caused from the diode not being centered on the lens? Or atleast the fact that it isn't equal on both side. When building modules I use centering mounts that I can adjust the position of the diode. You can then usually have the wing even on each side and use a spatial filter to clean them up.
 
Re: Open: Osram PL TB450B 1.6W (Substitute for the M140)

Hm. Mine didn't have a batwing. Agreeing with POLISHEDBALL that it looks like there is an alignment issue.
 
Re: Open: Osram PL TB450B 1.6W (Substitute for the M140)

Bump, I have a lens and can do an LPM video, though it looks as though it's no longer necessary with all
the other LPM results. There are only 3 diodes left to go before the buy is triggered. Where did everyone
go?
 
Re: Open: Osram PL TB450B 1.6W (Substitute for the M140)

I actually just listed my build for sale. If I sell it I will buy another diode and save it for a future build.
 
Re: Open: Osram PL TB450B 1.6W (Substitute for the M140)

I'll take one. Approximately how much will shipping be?
 
Re: Open: Osram PL TB450B 1.6W (Substitute for the M140)

Sorry to back out of a diode, but I no longer need another.

The good news is the diode that tested low power. Is working fine measures the same as the other one making 2w at 1.8a. Turns out it was in a bad host and not seating. Considering the time I ran this overheated it survived well. While it was in the bad host, I overdrove and heated it till it went down in power to LED. Mounting it correctly and it ran just fine. Held for 15 minutes no problem at 2w.
 
Re: Open: Osram PL TB450B 1.6W (Substitute for the M140)

POLISHEDBALL said:
Sorry to back out of a diode, but I no longer need another.

The good news is the diode that tested low power. Is working fine measures the same as the other one making 2w at 1.8a. Turns out it was in a bad host and not seating. Considering the time I ran this overheated it survived well. While it was in the bad host, I overdrove and heated it till it went down in power to LED. Mounting it correctly and it ran just fine. Held for 15 minutes no problem at 2w.
Click to expand...

Excellent, great to hear it. These are a really tough diode when it comes to heat. I'll take
you off the list then.

Mattronium said:
I'll take one. Approximately how much will shipping be?
Click to expand...

Shipping is $3. $5 if you want it insured. Figure another couple dollars on each diode for
the cost to ship it from the supplier. I won't know exactly until after they have been sent. I
lost my shirt on the first 5 because they had sent it FedEx express and FedEx decided to
let me know just the other day that it was over $75 and charge my credit card all at the
same time. Frankly their system sucks. Avoid it if you can. If you have already paid,
don't worry about it. So I'll put you down for one then I guess.
 
Re: Open: Osram PL TB450B 1.6W (Substitute for the M140)

I've missed this thread until now, I've been hibernating for a little while :whistle:

Looks like you have 1 or 2 left (?) I'd like to order at least one please :)


:beer:
 
Last edited:
Re: Open: Osram PL TB450B 1.6W (Substitute for the M140)

I don't have any on hand right now to sell, but I can put you down for the next round. The order can
hopefully go out soon if enough are interested. Exactly how many do you want?
 
Re: Open: Osram PL TB450B 1.6W (Substitute for the M140)

Please write me down for 2 of them, thanks!

:beer:
 
Re: Open: Osram PL TB450B 1.6W (Substitute for the M140)

as soon as i sell my wl e2 i'm in for 1. shouldn't be but a day or two.
 
Re: Open: Osram PL TB450B 1.6W (Substitute for the M140)

Any other power reports on these. Curious on if my meter might need some calibration.

Constant for me 1.8a is 2w.
 
You must log in or register to reply here.





Back
Top