803T GB #3 15.00 shipped done

styropyro · Nov 5, 2008

Re: 803T GB #3 15.00 shipped done

I paid and didn't write down my name. I bought a sled and an Aixiz module and my email is cactiking @ anthonyclan dot com.

jake21 · Nov 6, 2008

got ya sorry lots of people sent money but dident include the lpf name and got me kinda confussed but every thing is going out tomarrow

heruursciences · Nov 10, 2008

Re: 803T GB #3 15.00 shipped done

Got mine yesterday! Thanks for the marbles. ( FWIW, it appeared the sled failures were caused by pickup servo glue bonding failure, and a few that had a bad LC mode stabilizer)

The important part: All the violet diodes were fine

pwnstar · Nov 10, 2008

hey got mine today the sled looks good, but I think I am short a marble cause I was sopost to get a free one =[

styropyro · Nov 11, 2008

Re: 803T GB #3 15.00 shipped done

I got mine today, and when I open the box there was no marble or Aixiz module with my sled, I was pissed! Then I opened the sled box and saw the marble and module. ;D

luciday · Nov 12, 2008

Got mine yesterday, no marble here either. :-(

I knew the modules would be broken but the module looked like it had been run over by a truck, even the aluminum cast was fractured. Some parts (lens coils magnets) were even missing. A bit disappointed about that now that I hear that some did receive a module with a front lens and I had a purpose for it. Oh well..

The diode looks fine on the outside though and the aixiz modules are ok.

kernelpanic · Nov 12, 2008

luciday said:
Got mine yesterday, no marble here either. :-(

I knew the modules would be broken but the module looked like it had been run over by a truck, even the aluminum cast was fractured. Some parts (lens coils magnets) were even missing. A bit disappointed about that now that I hear that some did receive a module with a front lens and I had a purpose for it. Oh well..

The diode looks fine on the outside though and the aixiz modules are ok.

I can send you a lens if you pay the postage. I've got a couple lying around. PM me if you're interested... I'd probably send the whole sled. (minus the diodes and the magnets...)

cheers,
kernelpanic

Bearded_Galaxy · Nov 14, 2008

Sled arrived. I haven't checked to make sure it works, but I'm sure it will. The free crackle glass was a nice touch I'd forgotten about. Completely satisfactory (assuming my diode works).

goahead · Nov 14, 2008

Hello Jake. Received my sleds and aixiz today. The aixiz is ok, i'm sure the other sled will be fine too.

Thank you very much for this smooth going GB.

It has again been a pleasure to buy from you.

Ahmet

803T GB #3 15.00 shipped done

styropyro

0

jake21

0

heruursciences

0

pwnstar

0

styropyro

0

luciday

0

kernelpanic

0

Bearded_Galaxy

0

goahead

0

Online statistics

Forum statistics

Share this page