- Joined
- Jun 23, 2012
- Messages
- 46
- Points
- 0
I heard somewhere a while ago that you can use 405/445/450nm drivers such as the BlitzBuck v3 (290ma) to power red diodes (specifically a 3.8mm 300mw), is this true?
LPF Donation via Stripe | LPF Donation - Other Methods
Links below open in new window
ArcticMyst Security by Avery
Use 405/445/450nm drivers for 650nm diodes?
- Thread starter Daktah Pepah
- Start date
- Joined
- Jun 26, 2012
- Messages
- 788
- Points
- 28
Short answer: Yes.
- Joined
- Jun 23, 2012
- Messages
- 46
- Points
- 0
sweet
would you mind with the long answer too so i know exactly what to and not to do?
:thanks:
would you mind with the long answer too so i know exactly what to and not to do?
:thanks:
- Joined
- Jun 7, 2012
- Messages
- 1,683
- Points
- 63
Most of the info your looking for is on the forum stickies. Read around a bit and it should answer most of your questions.
- Joined
- Jun 26, 2012
- Messages
- 788
- Points
- 28
As long as it's outputting the current & voltage that your diode requires it will work. So just make sure that it meets the requirements of your diode.
