sbdwag
0
- Joined
- May 21, 2009
- Messages
- 135
- Points
- 0
Will it hurt a laser diode to use a diode tester on it?
Regards
sbdwag
Regards
sbdwag
LPF Donation via Stripe | LPF Donation - Other Methods
Links below open in new window
ArcticMyst Security by Avery
Testing a Laser Diode with a diode tester
- Thread starter sbdwag
- Start date
- Joined
- May 4, 2009
- Messages
- 5,443
- Points
- 113
prob not as they have current limiting resistors in circuit that limit to 5, 10 15 & 20 ma depending which hole you stick it in, at least thats the way I rember mine working befor it grew legs. I although would not try this the first time with a expensive LD, I would use a unwanted IR or a cheaper red type on my first try IMHO...
Have a good day sbdwag ! Pyro... :eg:
Have a good day sbdwag ! Pyro... :eg:
Last edited:
dr-ebert
0
- Joined
- Mar 8, 2009
- Messages
- 710
- Points
- 0
Just when I tried to submit my reply, the server went down...
Possibly yes. Laser diodes may have low voltages for the maximum permissible reverse voltage. I've checked the datasheet for a 635nm diode which had 2V max here, which was less than the normal operating forward voltage. Better use the pinout diagram.
Possibly yes. Laser diodes may have low voltages for the maximum permissible reverse voltage. I've checked the datasheet for a 635nm diode which had 2V max here, which was less than the normal operating forward voltage. Better use the pinout diagram.
- Joined
- Sep 20, 2008
- Messages
- 17,622
- Points
- 113
Most of my meters supply around 2 Volts on the Diode Check
position... But one of my more expensive meters outputs 3.17 Volts..
Jerry
position... But one of my more expensive meters outputs 3.17 Volts..
Jerry
sbdwag
0
- Joined
- May 21, 2009
- Messages
- 135
- Points
- 0
My bench multimeter use 2.95v for diode testing so for the IR diodes that specify 2.2volts dropped I should be able to forward bias it and see if its bad or good just like any other diode dont you think.
Surely if you reverse bias it with the few ma's supplied by the meter you would not blow thru the pn juction.
regards
sbdwag
Surely if you reverse bias it with the few ma's supplied by the meter you would not blow thru the pn juction.
regards
sbdwag
Last edited:
dr-ebert
0
- Joined
- Mar 8, 2009
- Messages
- 710
- Points
- 0
That's a bit like saying "If I bend my knee just a bit in a direction it's not meant to bend, it can't be painful"...
An IR diode should be more rugged than others, so it'll probably survive. It's yours anyway.
An IR diode should be more rugged than others, so it'll probably survive. It's yours anyway.
