- Joined
- Jan 8, 2009
- Messages
- 3,145
- Points
- 83
I want to power 2 drivers either at the same time as well as have the ability to run them independently. I thought of hooking both to the positive with separate grounds (running a tail switch).
I'm looking at one of those 1no1nc LED switches even found a 2no2nc LED ring push button I know there is a way.
If I was using a 9mm diode with a continues ground driver could I bridge the cathode to the host and the drivers - output?.:undecided: This would keep the switches - isolated to the switch then no, no that would work.:tsk:
I need some help I want to run the diode and a tec then I want to run just the tec alone.:beer:
I'm looking at one of those 1no1nc LED switches even found a 2no2nc LED ring push button I know there is a way.
If I was using a 9mm diode with a continues ground driver could I bridge the cathode to the host and the drivers - output?.:undecided: This would keep the switches - isolated to the switch then no, no that would work.:tsk:
I need some help I want to run the diode and a tec then I want to run just the tec alone.:beer: